Bearings

Radial & Deep Groove Ball Bearings

SKF Ball Bearing

SKF (MRC) Radial/Deep Groove Ball Bearing - Round Bore, 15 mm ID, 32 mm OD, 9 mm Width, Single Seal, Internal Clearance: C3Alternative: 6002-2RS1, 6002 RSJEM

SKF Deep Groove Ball bearing Corrosion Resistant

SKF These single row angular contact ball bearings can accommodate radial and axial loads acting simultaneously, where the axial load acts in one direction only. They can operate at high speeds and, depending on the variant, even very high speeds. They are more suitable than deep groove ball bearings for supporting large axial forces acting in one direction.High-speed capabilityAccommodate relatively high radial loads and large unilateral axial loads

Ball Bearing Unit, Cast iron, Pillow block, Low center height, set screw lock, 2-7/16 Shaft

four bolt ball bearing flange 3"

Two Bolt Ball Bearing pillow 3"

Spherical Roller Bearing - 60 mm ID, 130 mm OD, 46 mm Width, Straight Bore, CN

Cylindrical Roller Bearing - Straight, 60 mm ID, 110 mm OD, 2.8750 in Width, C0 Internal Clearance

35 mm ID, 72 mm OD, 17 mm Width, Double Shielded, C3 Internal Clearance

Angular Contact Bearing - 90 mm Bore, 190 mm OD, 43 mm Width, Open, 40 ° Contact Angle

Round Bore, 35 mm ID, 80 mm OD, 21 mm Width, Double Sealed, With Snap Ring, C3 Internal Clearance

SKF PumPac®, Angular Contact ball bearing set for locating bearings in centrifugal pumps

Thrust ball bearings, single directionBore diameter: 2.756 inHeight: 0.709 inOutside diameter: 3.74 in

Ball Bearing 2 Shields

Self-aligning ball

Deep groove ball bearing